On Linux kernels the size of the values exported for block
device bytes has used a 64 bit integer for quite some time
(2.6+ IIRC). Make the procfs value extraction use correct
types and change internal types used to rate convert these
counters (within the DiskIO Meter) 64 bit integers, where
appropriate.
On Linux kernels the size of the values exported for network
device bytes and packets has used a 64 bit integer for quite
some time (2.6+ IIRC). Make the procfs value extraction use
correct types and change internal types used to rate convert
these counters (within the NetworkIO Meter) 64 bit integers,
where appropriate.
Use similar calculation than procps.
Show AvailableMemory in text mode.
Use total minus available memory instead of manually computed used-
memory as fraction part in bar mode (if available).
The State struct holds a pointer to the main process panel.
Use the distinct MainPanel type, to improve maintainability regrading
its usage.
This avoids usages of down-casts from Panel to MainPanel, only up-casts
from MainPanel to Panel are now required.
At start, SysArchMeter calls the uname function to obtain the kernel
version and architecture. If available, the distro version is obtained
by calling lsb_release. The obtained values are stored in static
variables and used when updating the meter.
pgrp and session might be -1
linux/LinuxProcessList.c:312:20: runtime error: implicit conversion from type 'unsigned long' of value 18446744073709551615 (64-bit, unsigned) to type 'unsigned int' changed the value to 4294967295 (32-bit, unsigned)
SUMMARY: UndefinedBehaviorSanitizer: undefined-behavior linux/LinuxProcessList.c:312:20 in
linux/LinuxProcessList.c:314:23: runtime error: implicit conversion from type 'unsigned long' of value 18446744073709551615 (64-bit, unsigned) to type 'unsigned int' changed the value to 4294967295 (32-bit, unsigned)
SUMMARY: UndefinedBehaviorSanitizer: undefined-behavior linux/LinuxProcessList.c:314:23 in
- avoid UBSAN conversions
- print N/A on no data (i.e. as unprivileged user)
- fix rate calculation to show bytes (instead of a thousandth)
- print bytes as human number (i.e. 8MB) instead of 8388608
- stabilize sorting by adjusting NAN values to very tiny negative number
If no terminal name can be found, fall back to generic display method
with major and minor device numbers.
Print special value '(none)' in case both are zero.
On some AMD and Intel CPUs read()ing scaling_cur_freq is quite slow
(> 1ms). This delay accumulates for every core.
If the read on CPU 0 takes longer than 500us bail out and fall back to
reading the frequencies from /proc/cpuinfo.
Once the condition has been met, bail out early for the next couple of
scans.
Closes: #471
According to the Linux kernel documentation, "SwapCached" tracks "memory
that once was swapped out, is swapped back in but still also is
in the swapfile (if memory is needed it doesn't need to be swapped out
AGAIN because it is already in the swapfile. This saves I/O)."
It is only used on Linux to optimize memory handling in case the command
changes to a smaller-or-equal string.
This "optimization" however causes more code bloat and maintenance cost
on string handling issues than it gains.
